- acrylic latex stucco over foam insulation

Category

acrylic latex stucco over foam insulation -


Problems With Acrylic Stucco. Acrylic or synthetic stucco, also known as exterior insulation and finish systems (EIFS), has been used on home exteriors in the U.S. since the 1980s. It is cheaper and easier to work with than traditional cement stucco, but is not without its pitfalls. Acrylic stucco dents easier than cement and can lead to water. Figure 2 - Stucco is installed over rigid insulation, which is installed over a drainage plane consisting of a drainage gap and building wrap layer over the sheathing. Note the continuity of the thermal control layer via overlapping foam layers at the slab-to-wall interface.

Nov 05, 2013 · I would like to add rigid foam insulation on the outside, 1.75" or 2" and then either new stucco or furring strips and Hardie board. Also, will I need house wrap over the foam before I put the furring strips as there is no wood structure on the outside (nothing until the lath on the inside)? stucco with acrylic topcaot. Dana1 Senior. Mar 28, 2018 · I have a good handle on how to install siding over exterior foam but I'm not sure about the section of my house that will have a stucco look? I assume I want to go with an EIFS rather than pure stucco or am I making a bad assumption here? If I go with EIFS should I plan to install my 2" or 3" of polyiso in the EIFS locations assuming that the EIFS installer will utilize my polyiso or does the.

Aug 22, 2012 · Re: Stucco: Elastomeric Coatings vs. Acrylic Latex You are never supposed to paint three coat stucco, the proper procedure is to water-blast it and if necessary (usually the owner wants to change the color) you apply a new color coat. Install Foam Board. Install the foam insulation board over the base coat of mixture. This is a 1-inch board that is used to insulate and give the finished stucco some depth. There are several different kinds of this board, so choose the one that will give the best overall protection.Author: DIY Staff.